
Fe Støberiet A/S
Industrivænget 12, Lind
7400 Herning
+45 97 40 65 10
fe@fe-s.dk
We also Mould in Plastic
We offer as well moulding as machining of plastic components.
Injection Moulding
We use injection moulding for the manufacturing of parts in thermoplastic plastic.
Under high pressure the melted plastic is injected into the mould - a negative of the wanted figure.
Part weight: from 1 to 8,000 gram
Mould
By the manufacturing of the mould, it is important that the part can be de-moulded, and at the same time make sure that the mould is completely full before drying.
Types of Plastic by Fe Støberiet A/S
The most common used materials for injection is:
Polystyrene. Cheap, but with weaker abilities than other materials.
PE-HD (Polyethylene). High Density.
PE-LD (Polyethylene). Low Density.
Other materials for moulding
ABS (Akrylnitril Butadien Styrene).
PA (Polyamid, Nylon). Resistant to heat and chemicals..
Polypropylen. Strong and flexible.
Fe Støberiet A/S • Industrivænget 12, Lind • 7400 Herning • +45 97 40 65 10 •
fe @ fe-s .dk